| General Information | ||
En |
| This system complies with the FCC rules, | |
| Part 15 and with 21 CFR 1040.10. | ||
gli |
| Operation is subject to the following two | |
sh |
| conditions: | |
|
| – This device may not cause harmful | |
|
| interference, and | |
|
| – This device must accept any interference | |
|
| received, including interference that may | |
|
| cause undesired operation. | |
|
|
|
|
|
| Environmental Information | |
|
| All unnecessary packaging has been omitted. We | |
|
| have tried to make the packaging easy to | |
|
| separate into three materials: cardboard (box), | |
|
| polystyrene foam (buffer) and polyethylene (bags, | |
|
| protective foam sheet). | |
|
| Your system consists of materials which can be | |
|
| recycled and reused if disassembled by a | |
|
| specialized company. Please observe the local | |
|
| regulations regarding the disposal of packaging | |
|
| materials, exhausted batteries and old | |
|
| equipment. | |
|
|
|
|
|
| Acknowledgement | |
|
| Energy Star |
|
|
|
| |
|
| As an ENERGY STARR |
|
|
| Partner, Philips has |
|
|
| determined that this product |
|
|
| meets the ENERGY STARR |
|
|
| guidelines for energy efficiency. | |
Supplied accessories
–Remote control
–Batteries (two AA size) for remote control
–AM loop antenna
–FM wire antenna
–AC power cord
8
pg | 8 |
Safety Information
●Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer.
●Place the system on a flat, hard and stable surface.
●Place the system in a location with adequate ventilation to prevent internal heat
●Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.
●If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.
●The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.
●When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.
12/11/01, 5:25 PM 3139 115 21151
