|
| TROUBLESHOOTING |
|
|
|
|
|
| Problem | Cause | Solution |
|
|
|
|
| NO SOUND | • Power AC lead unplugged or power not | • Check if AC lead is plugged in and |
|
| switched on | power switched on |
|
| • Tape 2 Monitor selected | • |
|
| • Mute on | • Switch off Mute |
|
| • Speakers not switched on | • Switch Speakers on |
|
|
|
|
| NO SOUND ONE CHANNEL | • Speaker not properly connected or | • Check connections and speakers |
|
| damaged |
|
|
| • Input lead disconnected or damaged | • Check leads and connections |
|
|
|
|
| NO SOUND ON SURROUND CHANNELS | • No surround mode selected | • Select a Surround Mode |
|
| • Mono sound source | • Test system with Stereo or Dolby |
|
|
| Surround material |
|
| • Speakers not properly connected | • Check speakers and connections |
|
| • Surround volume level too low | • Increase surround volume level |
|
|
|
|
| NO SOUND ON CENTER CHANNEL | • In Setup “NONE” for center speaker | • Select appropriate Center mode (large |
|
| selected | or small) |
|
| • | • Select Surround Mode |
|
| • Speaker not connected properly | • Check Speaker and connection |
|
| • Center volume level set too low | • Increase center volume level |
|
|
|
|
| NO SOUND IN ‘SURROUND OFF’ WITH | • Analogue connections from source not | • Connect analogue connections from |
| DIGITAL INPUT | connected to T770 | digital source as well |
|
|
|
|
| NOT POSSBILE TO SELECT “DOLBY DIGITAL” | • Source not connected using digital | • Connect digital output of source to T770 |
|
| in/outputs |
|
|
| • Digital input has not been assigned to | • Assign the digital input used to selected |
|
| selected input | input |
|
|
|
|
| WEAK BASS/ DIFFUSE STEREO IMAGE | • Speakers wired out of phase | • Check connections to all speakers in |
|
|
| the system |
|
|
|
|
| REMOTE CONTROL HANDSET NOT | • Batteries flat, or incorrectly inserted | • Check or replace batteries |
| WORKING | • IR transmitter or receiver windows | • Remove obstruction |
|
| obstructed |
|
|
| • IR receiver in direct sun or very bright | • Place unit away from direct sun, reduce |
|
| ambient light | amount of ambient light |
|
|
|
|
| NO SOUND WITH TUNER | • Antenna leads incorrectly connected | • Check antenna connections to receiver |
GB |
| • Station not selected or weak signal with | • |
| FM Mute on |
| |
|
|
| |
NOISE, HISS ON AM AND FM | • Weak signal | • Check station tuning. Adjust or replace | |
|
|
| antenna |
|
|
|
|
| DISTORTION ON FM | • | • Check station tuning. Adjust or replace |
|
| another station | antenna |
|
|
|
|
| WHISTLES OR BUZZES ON FM & AM | • Interference from other electrical | • Check station tuning. Switch off or |
|
| sources - computers, games consoles | move the source of the electrical noise |
|
|
|
|
| WHISTLES OR BUZZES ON AM | • Interference from fluorescent lighting | • Check station tuning. Adjust or replace |
|
| or electrical motors | AM antenna |
|
|
|
|
| NO RDS NAME (PS) | • Station signal too weak | • Check station tuning. Adjust or replace |
|
|
| antenna |
|
| • Station not transmitting RDS data | • No remedy |
|
|
|
|
20