Harmonic Distortion; FM Mono
Harmonic Distortion; FM Stereo
Signal/noise; Mono
Signal/noise; Stereo
Stereo separation at 1kHz
Frequency response; + 1.5dB
XM Ready
Video Section
Input and output impedance
Component Video Bandwidth
HDMI – Audio + Video
Physical Specifications
Net Dimensions (W x H x D)
Gross Dimensions (W x H x D)*
Net Weight
0.25%
0.5%
60dB
55dB
40dB
30Hz - 15kHz
Yes
75 Ohms
50MHz
Yes
17 1/8 x 7 1/8 x 15”
(435 x 180 x 382mm)
17 1/8 x 7 5/8 x 16 9/16”
(435 x 194 x 421mm)
55 lbs (25kg)
SPECIFICATIONS
Amplifier Section
Simultaneous Full Disclosure Power
(4/8 Ohms, 20Hz - 20kHz, at rated distortion)
Minimum Continuous Power (FTC)
Power Output Stereo Mode
(8
Ohms within rated distortion)
IHF dynamic power; 8 Ohms
IHF dynamic power; 4 Ohms
IHF dynamic power; 2 Ohms
Total harmonic distortion at rated power
IM distortion at rated power
Damping factor 8 Ohms
Input sensitivity and impedance
Frequency response
Signal/noise ratio; ref rated power 8 Ohms
Signal/noise ratio; ref 1W / 8 Ohms
Remote Controls
Tuner Section
Input sensitivity Mono
50dB Stereo:
7 x 120W (20.8dBW)
7 x 190W(22.8dbW)
2 x 150W (21.8dbW)
2 x 250W (23.9dBW)
2 x 350W (25.4dBW)
2 x 450W (26.5dBW)
0.05%
0.05%
60
400mV / 50k Ohms
10 to 20,000 Hz ±0.3dB
>90dB
>80dB
HTRC-1 (main) / ZR-4 (2nd zone)
16.1dBf
36.1dBf
NAD Electronics International reserves the right to change specications or features without notice. NAD is a registered trademark of NAD Electronics
International. All rights reserved. No part of this publication may be reproduced, stored, or transmitted in any form whatsoever without the written
permission of NAD Electronics International. © 08/07 NAD Electronics International.

www.NADelectronics.com

* Gross dimensions include volume knob / speaker terminals / connectors / feet.
Note: Installers should allow a minimum clearance of 2 - 4 inches for
wire management.