Nady Systems 3WA1700 S P E C I F I C At I O N S, Output Section, Input Section, General

	S P E C I F I C AT I O N S
1. OUTPUT SECTION
Power Output (all channels driven simultaneously, 1% THD)
Channel 1 & 2	300W RMS per side @ 8Ω
	450W RMS per side @ 4Ω
Subwoofer	550W RMS @ 8Ω
	800W RMS @ 4Ω
Ch 1 & 2 “Touch-proof” binding posts (banana jack) outputs
Damping Factor (20Hz – 400Hz @ 8Ω)		> 250
Slew Rate (1KHz @ 2 x 4Ω)		6.5V / uS
Frequency Response	10Hz ~ 50KHz (- 2dB)
THD + Noise		0.04%
S/N Ratio		- 86dBm
Noise Floor		3mV
Total Gain		40dB
Amplifier Protection	Four variable speed fans for cooling; Power On/Off relay; RF protection; DC offset protection circuits;
	thermal overload protection; short circuit protection
2. INPUT SECTION
Sub, Ch 1 & 2 balanced XLR and 1/4” TRS
Input Impedance balanced / unbalanced		40KΩ / 20KΩ
Sensitivity (level control set to max)
Ch 1 & 2 balanced / unbalanced	-3.8dBm, 500mV / +2.2dBm, 1V
Sub balanced / unbalanced	-2.1dBm, 600mV / +3.8dBm, 1.2V
Max Input Level (Level control set to Mid)		>5V, +16.2dBm
Controls	Rear: Filter/Source selector, Low Cut
	Front: Power switch, Ch A & B Level controls
Low Pass Filter	adjustable 50Hz – 250Hz	(-12dB/octave)
Low Cut (high pass filter)	fixed 30Hz	(-12dB/octave)
LED Indicators
Sub, Ch 1 & 2 Signal	3 x green LED light at 110mV
Sub, Ch 1 & 2 Clipping	3 x red LED light 3dB before clipping
Sub, Ch 1 & 2 Protect		3 x Red LED
Power On		1 x Blue LED
3. GENERAL
Power Requirements		115VAC/60Hz
Fuse Requirements	3AG 20A 250V glass tube fast-blow
Weight		46.2 lbs. (21Kg)
Dimensions (HWD)	3.5” x 19.0” x 17.2” (88.8 x 483 x 436mm)

The specifications above are correct at the time of printing of this manual. For improvement purposes, all specifications for this unit, including design and appearance, are subject to change without prior notice.

9