CONTROLS AND CONNECTIONS
115V/60Hz
230V/50Hz
XLR | R CHANNEL |
|
| SUB |
| L CHANNEL |
|
|
BALANCE D |
|
|
|
|
| |||
PIN 1 GND |
|
|
|
|
|
|
|
|
PIN 2 HI |
|
|
|
|
|
|
|
|
PIN 3 LO |
|
|
|
|
|
|
|
|
PHONE UNBAL |
|
|
|
|
|
|
|
|
AC IN |
|
|
|
|
|
|
|
|
FUSE 0.5A | OUTPUT | LOW | INPUT | WOOFER | HIGH | OUTPUT | LOW | INPUT |
HIGH |
NADY SYSTEMS, Inc.
Emeryville, CA, USA
Made in Taiwan
12 | 13 | 9 | 11 | 10 | 11 | 11 | 10 |
REAR PANEL
9.FUSE COMPARTMENT:
Replace with only the same type fuse (0.5A/250V). If it blows continuously, do not use the unit until it has been serviced by qualified personnel.
10.STEREO INPUT CONNECTORS:
Connect your L/R stereo input signal to either the balanced XLR or the unbalanced 1/4" phone jacks.
11.OUTPUT CONNECTORS:
Connect to your amplifiers via these unbalanced 1/4" phone jacks.
12.AC VOLTAGE SELECTOR SWITCH:
Before plugging in the power cord, check to see that the unit is set for the proper voltage for your area:~115V (60Hz) or ~230V (50Hz).
13.POWER CONNECTOR
The IEC jack is used to connect the power cord to the AC Power Source. (Caution: Do not remove the center grounding pin.)
SPECIFICATIONS | |
Crossover Type | Stereo 2 ways + Subwoofer |
Crossover Range | Subwoofer: 50 - 250Hz, |
| Low/High : |
Filter Type (Slope) | 2nd order, 12dB/Octave |
Inputs |
|
Type | Balanced XLR and unbalanced 1/4" |
Impedance | 100KΩ |
Outputs |
|
Type | Unbalanced 1/4" |
Impedance | 220 Ω |
Low Cut Filters | 30Hz/ - 3dB, 12dB/Octave |
Frequency Response | 20Hz - 25KHz |
Total Harmonic Distortion (THD) + Noise | < 0.05 % |
S/N Ratio | > 95 dB |
Fuse | 0.5 A/ 250V, 5mm glass type |
Dimensions | 19’’ x 1.73’’ x 5.9’’ (483 X 44 X 150mm) |
Weight | 4.4 lbs. (2.2 Kg) |
Specifications and design subject to change without prior notice for improvement purposes
5
