Nady Systems CX-22SW Please Read this Manual Before Operating this Unit, Controls and Connections

PLEASE READ THIS MANUAL BEFORE OPERATING THIS UNIT

Caution : To prevent malfunctioning and/or possible equipment damage:

Before plugging the unit into the power source: (1) the voltage selector switch should be set for the correct voltage for your area (115V or 230V) and (2) all equipment connected to the crossover outputs should be turned off or all the inputs turned down.

3 3 6 3 4

4 2 5 7 8 2 3 5 1

115V/60Hz

230V/50Hz

XLR	R CHANNEL	SUB	L CHANNEL
BALANCED

PIN 1 GND

PIN 2 HI

PIN 3 LO

RCA UNBAL

NADY SYSTEMS, Inc.

Emeryville, CA, USA

Made in Taiwan

AC IN

FUSE 0.5A

HIGH OUTPUT LOW INPUT WOOFER HIGH OUTPUT LOW INPUT

13 12 9 11 10 11 11 10

CONTROLS AND CONNECTIONS

CONTROLS

1.ON/OFF SWITCH

Caution: Always turn the Crossover ON before the amplifier, and turn it OFF after the amplifier or transients harmful to the speakers may result .

2.CROSSOVER FREQUENCY CONTROLS:

These select the crossover frequencies of the LOW and HIGH ways. They’re a low cut for the HIGH and a high cut for the LOW. You can Select the frequencies between 250 Hz and 6 Hz.

3.L/H OUTPUT LEVEL CONTROLS:

These are used to adjust the output level of each way: LOW and HIGH .

4.LOW CUT SWITCHES FOR LOW WAY:

These insert low cut filters in the LOW way of each stereo channel with a 12dB/Octave, 30 Hz HPF to minimize problems from subsonic frequencies in the signal, to suppress hum, and to prevent low frequency speaker resonance.

4