REAR CONNECTIONS

(12)

(11)

(10)

(15)

(14)

(13)

 

 

 

 

REAR PANEL

(10) TAPE IN AND TAPE OUT

The TAPE IN allows cassette recorders or CD players to be added to the Main output. The RECORD OUTPUT, with TAPE RCA jacks, provides signal output to a recording deck or home audio equipment. The nominal output level and impedance are -10dBV/600 ohms.

(11)POWER SWITCH

Turns the unit ON or OFF. Always turn level controls down before turning on the unit.

(12) VOLTAGE SELECTOR SWITCH

For selecting the proper voltage (115/230VAC) to match the power supply in your area.

Note: To avoid damage to your unit, always make sure this switch is set to the correct supply voltage. Damage caused by improper use is not covered by the warranty.

(13) POWER CONNECTOR WITH FUSE HOLDER

This standard IEC power cord receptacle is used to connect the AC power to your unit. It features a built-in fuse holder for a 5X20mm, (4A/250V for 115VAC, and 2A/250V for 230VAC operation) fast-blow fuse. If the fuse continuously blows, shut off the unit and have it serviced by qualified service personnel.

(14) MONO SPEAKER OUTPUTS

These 1/4” (6.3mm) jacks are daisy-chained together internally and powered by the mono amplifier output stage. Use speaker cables to connect these jacks to your speaker cabinets.

CAUTION: The minimum allowed total impedance connected to the mono amplifier is 4 ohms ( 8 ohms per output). Connecting speaker loads with less than 4 ohms total

impedance will degrade performance and may harm the amp. Damage to the amp caused by connecting less than a 4 ohms speaker load is NOT covered by the warranty.

(15) MAIN OUT/AMP IN

This unbalanced insert point is a break between the main out and the mixer main signal and the main amplifier. This insert is a 1/4” TRS phone jack that is normally bypassed. When a 1/4” TRS phone plug is inserted, the signal path is broken. Depending on the wiring of the plug inserted into this jack, the MPM 8175x can be used as either a mixer for a power amplifier or as a power amplifier for an external input line level signal from a preamp or mixer. Alternatively the jack can be used as an insert point for an external effects device to process the output signal from the mixer section of the MPM 8175x and return it pre the power amplifier

6

Page 6
Image 6
Nady Systems MPM 8175x owner manual Rear Connections, Rear Panel