Nady Systems MSE-100A owner manual Rear Panel Controls and Connections

REAR PANEL CONTROLS AND CONNECTIONS

13

14 12 11 10 11 10

10.INPUTS

The MSE-100A is equipped with both 1/4” (6.3mm) TRS and XLR audio input jacks. These can be used for either bal- anced or unbalanced operation as follows:

• Unbalanced use of mono 1/4” plugs:

Tip = Signal, Sleeve = Ground / Shield.

• Balanced use of TRS stereo 1/4” plugs:

Tip = hot (+), Ring = cold (-), Sleeve = Ground / Shield.

•Balanced use with XLR connectors:

1= Ground / Shield, 2 = hot (+), 3 = cold (-).

11.OUTPUTS

The audio outputs of the MSE-100A are matching phone jack and XLR connectors wired in parallel.

• Balanced use of stereo 1/4” jack/plugs:

Tip = hot (+), Ring = cold (-), Sleeve = Ground / Shield

•Balanced use with XLR connectors:

1= Ground / Shield, 2 = hot (+), 3 = cold (-).

12.FUSE HOLDER

The IEC power socket has an integral fuse holder that takes a 20mm fuse.

NOTE: Always replace a blown fuse with the same type as specified on the rear of the unit.

13 . POWER CONNECTION

A standard IEC AC power socket for connecting to the main AC supply.

Note: Before you connect your Enhancer to the AC, please make sure that your local voltage matches the voltage re- quired by the unit!

Note: Do not remove the center ground conductor.

14 . VOLTAGE SELECTOR SWITCH

For selecting the proper voltage (115/230VAC) to match the power supply in your area.

7