Nady Systems SPA 850 owner manual Connections, Stereo Two-ChannelMode

CONNECTIONS

The following instructions describe the most common ways to install your amplifier into a sound system.

1.Turn off the amplifier power switch before making any connections.

2.The XA Series amplifiers maybe operated in one of three modes (stereo, bridged-mono, and parallel mono). Refer to the following wiring diagrams for the speaker connections you wish to make.

(Note: Nady Systems assumes no liability for damaged speakers resulting from improper wiring, careless amplifier use, or over powering.)

• Stereo (Two-Channel) Mode

To put the amplifier into stereo mode, first turn the amplifier off, then slide the MODE SELECTOR SWITCH (13) to the bottom “STEREO” position, and properly connect the input/output wiring as shown.

(Note: Do not connect a speaker load less than 2 ohms as it can damage your amplifier.)

CHANNEL B

CHANNEL A

7