Nady Systems SW-1KU owner manual The AUTO-SCAN /ASC IR Sync Button 2 has two functions

During manual programming, the selected function will flash for five seconds or press the Set button to confirm the selection and the display will return to the main menu.

The AUTO-SCAN / ASC (IR Sync) Button (2) has two functions:

•Long press (hold ~2 seconds) for AUTO- SCAN for finding a clear channel within the frequency band (with all TXs turned off at this time). Clockwise running segments on the LCD display show the scanning

is in progress which normally takes ten seconds. When it finds an interference- free channel, it will display and store that channel for use. Then ASC IR Sync the TX as described below.

•Short press (hold ~ 1 second) to transfer the selected frequency information from the receiver to the transmitter for easy synchronization prior the transmitter can be used. When short pressing the ASC IR Sync button while the main menu is displayed, the IR LED (4) will light up red and stay for about five seconds. This indicates IR transmission is in progress and IR data is transferring during this period. A transmitter should be used

at this time to receive data from the receiver (see IR Sync Programming in Programming sections of HT-1KU and BT-1KU transmitter sections). Upon successful data transferred (usually in about three seconds) the IR LED stops and the transmitter’s backlight will light up and the transmitter will transmit a radio signal on the same channel as the receiver. The Signal Strength and Diversity Indicators on the receiver’s display will then light up, indicating that the IR link is completed. If manual channel selection is preferred, skip this selection.

Note: If you are using multiple transmitters at the same location, set up the first transmitter and leave it ON and keep it 3 ft. away from the receivers. Then start AUTO-SCAN on the second receiver. This avoids duplicate selection

of the same channel as already selected for the first receiver. Repeat these procedures for the remaining receivers to be used with the system.

If you are not satisfied with a channel after scanning, repeat anytime for locating another free channel.

Selecting the 8W-1KU Receiver Volume Level / Group / Channel

This section will also aid in finding desired channel(s) of operation when setting up your system(s).

Press the Set Button (6) 3 times to check the current Volume Levels (12) setting. To change the Volume Levels, press the (Up) or (Down) Buttons (7) anytime for single stepping, or hold the Up/Down button continuously for faster level selection. Select 1 of 63 (soft to loud sound) levels from the Volume menu and advance to exit Setup Mode by pressing the Set Button one more time. Selecting 0 should mute the receiver and no output for the Line Out only. The XLR out is unaffected.

Choose the 8W-1KU operating frequency by selecting one of 10 Groups (9) and one of 100 Channels (10) that are determined to be desirable open channels. Press the Set button to enter the Group setup mode and the Group icon will flash, then press the Up/Down button once for single stepping through the groups, or hold continuously for faster group selection. Select 1 of 10 groups available from the Group menu and then press the Set button again to Channel Setup Mode and the Channel icon will flash, or press the Set button three times to skip changing the Channel or Volume. Within the Channel Setup menu, press the Up/Down button once for single stepping through the channels, or hold continuously for faster channel selection. Select 1 of 100 channels available from the Channel menu or press the Set button twice to skip Volume Level setting and exit to main menu. During manual programming, the selected function

9