5. SYSTEM OPERATION
Button Function
The POWER ON Button (1) is used to power receiver ON or OFF. When the power button is pressed, the POWER LED (2) and the white backlight on the LCD DISPLAY (5) will light up indicating the receiver is ready. Press the Power button again to turn off the receiver. The power LED and the backlight on the LCD will be off indicating the receiver is off. At
The UP BUTTON (16) is pressed one step at a time to SCAN, IR or to increase GROUP, CHANNEL, MUTE by one level each time
The DOWN BUTTON (17) is pressed one step at a time to decrease GROUP, CHANNEL, MUTE by one level each time
The MENU BUTTON (18) is pressed one step at a time for Auto Scan Frequency or to Automatic GR/CH ASC™ Sync, or if pressed repeatedly the LCD DISPLAY (5) menu will cycle through the following screens.v
During manual programming, press the MENU BUTTON (18) to confirm the selec- tion and advance to the next menu before the Auto Programming Function takes over after 5 sec.
Rack Mounting the Receiver
There are 2 options available for rack mounting the
a. Single mounting: Remove the receiver SIDE MOUNT CLIP (24) from each side of the receiver (as shown) and slide in the optional
b.
(Note: Do not mount the receiver in a rack directly above an amplifier or other source of high heat — this could degrade the performance of the
8