21
OPTIONAL BLOWER INSTALLATION
black | red |
|
white
FIGURE 41
INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be electrically connected and grounded in ac- cordance with local codes. In the absense of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States
Attach the connectors from the black and white wires to the thermodisc
and secure the thermodisc bracket to the securing stud at the bot- tom left of the unit using a lock washer and wing nut. Ensure that the thermodisc touches the firebox wall.
Attach the connectors from the black and red wires to the blower.
Attach and secure the vari- able speed switch using the nut provided. Plug the harness cord into the re- ceptacle.
THERMODISC
RECEPTACLE / 
JUNCTIONBOX
GROUND
SCREW
FIGURE 45
If the fireplace was not previously equipped with a blower: route a grounded
FIGURE 46
The three slots on the
blower mounting bracket allow ease of
adjustment when attaching the blower. For a quiet running blower, do not allow the assembly to sit on the firebox base.
ELONGATED
SLOTS
FIGURE 42
The wire harness provided in this kit is a universal harness. When installed, ensure that any excess wire is contained, preventing it from making con- tact with moving or hot objects.
Because the blower is thermally activated, when turned on, it will automatically start approximately 10 minutes after lighting the fireplace and will run for approximately
Slide the vibration reducing pad (A) into the clip (C) and up against the threaded stud (B) at the other end. The blower must be able to be positioned entirely onto the pad.
Tilt the blower onto its side. Slide it past the controls and into the clip (C). Secure to the threaded stud using the lock washer and wing nut provided. Ensure that the blower does not touch the fireplace base or the firebox.
B
AC
place has been turned off. Use of the fan increases the output of heat.
Drywall dust will penetrate into the blower bear- ings, causing irreparable damage. Care must be taken to prevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from this condition is not cov- ered by the warranty policy.
FIGURE 43 | FIGURE 44 |
