1101 FAN SERVICE OR REPLACEMENT
1.Turn off all electrical power to the insert. Remove the glass door and set aside in a safe place.
2. Remove the top right side bricks from inside the firebox,
9
1401 FAN SERVICE OR REPLACEMENT
1.Turn off all electrical power to the insert. Remove the glass door and set aside in a safe place.
2.Remove the two screws from the outer edge of the side panel(s).
3.Push the side panel toward the door and pull away from the insert, releasing the panel from the keyed slot.
4.Service or replace the fan(s) as required.
5.
3. The access panel can be removed by taking out the 8 #10 self taping
HEAT
G B
screws. A 5/16" nut driver will be required to com- plete this job. Unplug wires from the thermal switch on the panel. See
FIGURE 13.
4.Remove the securing wingnut from the fan mounting bracket, slide the bracket to the right and rotate the left side of the assembly out of the cavity to clear the blower motor. Disconnect the two wires from the fan motor. Re- move the ground wire from the fan mounting bracket, then the assembly can be taken out of the rear cavity through the access door opening.
5.Remove the 3 screws that hold the fan to the mount- ing bracket. Service or replace the fan as required.
| GROUND STUD | SECURING |
|
| |
|
| ||||
|
| WINGNUT | TAB |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FIGURE 14
6. Reinstall the blower assembly WIRES making sure the blower bracket is seated under the securing tab.
FIGURE 14. Reattach the wire con- nectors. FIGURE 15.
7.Replace the gasket on the ac- cess door. To replace the access panel, reverse Step 3 .
8.Replace the bricks into the fire- box. Reinstall the door.
SENSOR
W
FIGURE 16
FIGURE 15
