17
W415-0583 / D / 07.24.07
UNDERSIDE OF ROCK CLUSTER
3. Carefully place the rocks on the bowl by lining up the
locating notch on the underside of the rock cluster with the
opening in the rear of the bowl. (Fig. 39)

FIGURE 37 FIGURE 38

TOP

EDGES

BOTTOM

EDGES

Next, remove the 6 screws that secure the burner base. Once
the gas has been disconnected, the burner train assembly
will lift out.
TOP SIDE OF ROCK CLUSTER
4. After rocks have been placed on the bowl, add the
remaining rock by inserting the pin into the hole shown in
Fig 40.

FIGURE 40

CURVED DECORATIVE PANEL REMOVAL

Insert a gloved hand behind the top right hand corner of the
panel and pull forward gently. Slide your hand down along
the edge of the panel allowing it to come out of its place in
the fi rebox and to rest on the edge of the fi rebox opening.
Repeat on the left side. Guide the panel out of the fi rebox
by rotating it carefully from the left to the right, being sure to
stay clear of the burner. (Fig. 40) Note: Be careful when
bending the panel not to bend the panel out of shape
permanently.
BURNER BASE REMOVAL

FIGURE 39

BOWL, MESH & ROCK REPLACEMENT
SCREW W/ SPACER
1. Carefully slide the opening in the rear of the bowl over
the burner making sure to line the holes in the bottom of
the bowl with the 2 locating pins on the burner bottom.
(Fig. 37)
2. Place the steel mesh inside the bowl making sure there
is even space between the mesh and edge of bowl.
(Fig. 38)

FIGURE 36