Napoleon Fireplaces GD82NT-T, GD82PT-T HAND HELD REMOTE OPERATIONS, TIME OUT, FIREPLACE OPERATION

W415-0583 / D / 07.24.07

2. FLAME HEIGHT

This function allows remote control of the ﬂ ame height.

Check that the Remote Control is on, otherwise, turn on

the Remote Control and wait 5 seconds. Select the manual

ﬂ ame height until the cursor (small triangle) is to the left of

the big ﬂ ame. (Fig. 47) Use the RIGHT or LEFT button to

set the desired ﬂ ame height. Six ﬂ ame levels are included,

from 1 (minimum) to 6 (maximum). An acoustic signal

from the Receiver conﬁ rms the reception of the command.

3. AUTOMATIC CHANGE OF FLAME HEIGHT

The system is provided with three automatic sequences to

change continuously the ﬂ ame height. Thirty steps compose

each sequence with an interval between one step and the

other of 5 seconds, for a total duration of 2.5 minutes. At the

end the sequence repeats continually until the sequence

function is changed to an alternate pattern or turned to off.

The Remote Control can select one of the predeﬁ ned se-

quences. Use the UP or Down button until the cursor (small

triangle) is to the left of the two small ﬂ ames. (Fig. 48)

Use the left or right button to select sequence 1, 2 or 3. When

using the sequence function the room thermostat is active.

4. ROOM THERMOSTAT

The Remote Control can operate as a room thermostat.

To activate this function use the UP and DOWN key until the

cursor (small triangle) is left of the thermometer icon.

Then use the right of left button to set the desired room

temperature. (Fig. 49)

This control system will cycle automatically the appliance on

or off to maintain the selected temperature.

FIGURE 47

FIGURE 48

HAND HELD REMOTE OPERATIONSTIME OUT

If the appliance is turned on and the Receiver does not receive

any command for 24 hours, it automatically turns the appliance

and the Remote Control off.

To operate this ﬁ replace using the remote, the pilot must be

running and the gas valve turned to the “ON” position. Ensure

that the receiver has power and the backup switch is in the

auto position.

1. Install the batteries (AAA) into the remote control

transmitter. The “HOUSE” icon with room temperature will

be displayed.

2. Press the ON/OFF button on the remote. Icons

will appear at the same time and acoustic signal is

generated if not, move the transmitter closer to the re-

ceiver and repeat. If a signal is still not heard, it will be

necessary to execute the address setting procedure.

Note: There maybe a few seconds delay before the receiver

responds. Especially when using the wrought iron face-

plate.

3. Fahrenheit - Celsius temperature indicatior

It is possible to set the Remote Control transmitter to display

the temperatures in either Fahrenheit or Celsius. Use the UP

or DOWN button on the transmitter until the cursor (small

triangle) is left of the clock icon.

4. From time 0:00 press the LEFT key ten times. The display

will show the transmitter address. Use the RIGHT button to

toggle from °F to °C and vice versa. The display will show

the selected unit of measue. Press the LEFT button to exit

this function.

FIREPLACE OPERATION

FIGURE 39

1. ON / OFF

To turn the ﬁ replace on press the ON / OFF button, the

ﬁ replace will always light at maximum ﬂ ame setting. Press

the ON / OFF button again to turn the ﬁ replace off.