2
W415-0223 / D / 01.12.04
Pg 2-4 INTRODUCTION
Warranty
General Instructions
General Information
Care of Glass & Plated Parts
5-7 INSTALLATION
Insert Vent Connection
Chimney Connection
Wall Switch / Thermostat
Gas Pipe Installation
7-8 FINISHING
Trim Extrusion Installation
Log Placement
Door Installation
Mantle Clearances
Logo Placement
Pg 9 OPERATION / MAINTENANCE
Operating Instructions
Maintenance
10 REPLACEMENT BLOWER
11 ADJUSTMENTS
Pilot Burner Adjustment
Vent Restrictions
Venturi Adjustments
12-13 REPLACEMENTS
Ordering Replacement Parts
Replacement Parts
Terminal Kits
Accessories
14-15 TROUBLE SHOOTING GUIDE
16 SERVICE HISTORY
NOTE: changes, other than editorial, are denoted by a vertical line in the margin.
WARNING
• The fireplace insert is a vented gas-fired heater . Do not burn wood or other materials in this fireplace insert.
• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay
away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the
fireplace insert.
• Due to high temperatures, the fireplace insert should be located out of traffic and away from furniture and
draperies.
• Clothing or other flammable material should not be placed on or near the fireplace insert.
• Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace insert.
• It is imperative that the control compartments, burners and circulating blower and its passageway in the
fireplace insert and venting system are kept clean. The fireplace insert and its venting system should be
inspected before use and at least annually by a qualified service person. More frequent cleaning may be
required due to excessive lint from carpeting, bedding material, etc. The fireplace insert area must be kept
clear and free from combustible materials, gasoline and other flammable vapours and liquids.
• Under no circumstances should this fireplace insert be modified.
• This fireplace insert must not be connected to a chimney flue pipe serving a separate solid fuel burning
appliance.
• Do not use this fireplace insert if any part has been under water . Immediately call a qualified service technician
to inspect the fireplace insert and to replace any part of the control system and any gas control which has
been under water.
• Do not operate the fireplace insert with the glass door opened, cracked or broken. Replacement of the glass
should be done by a licensed or qualified service person.
• Do not strike or slam shut the fireplace insert glass door.
• This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple
supplied by Wolf Steel Ltd.
TABLE of CONTENTS