Napoleon Fireplaces GI 3600-P, GI 3600-N manual Maintenance, For Your Safety Read Before Lighting

						9
		FOR YOUR SAFETY READ BEFORE LIGHTING:
A This fireplace has a pilot which must be lit by hand				turn by hand, do not try to repair it. Call a qualified ser-
while following these instructions exactly.				vice technician. Force or attempted repair may result in
B Before lighting, smell all around the fireplace area for				a fire or explosion.
gas and next to the floor because some gas is heavier			D Do not use this fireplace if any part has been under
than air and will settle on the floor.				water. Immediately call a qualified service technician
C Use only your hand to push in or turn the gas control				to inspect the unit and replace any part of the control
knob. Never use tools. If the knob will not push in or				system and any gas control touched by water.
		WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.			•	Immediately call your gas supplier from a neighbour's
• Do not touch any electrical switch; do not use any phone				phone. Follow the gas supplier's instructions.
in your building.			•	If you cannot reach your gas supplier, call the fire de-
				partment.
		LIGHTING INSTRUCTIONS
1.Stop! Read all the safety information above. When light-			8.Depress and hold the gas knob while lighting the pilot
ing and re-lighting, the gas knob cannot be turned from			with the push button ignitor. Keep the knob fully depressed
"pilot" to "off" unless the knob is depressed.			for one (1) minute, then release. If the pilot does not con-
2.Turn off all electrical power to the stove.			tinue to burn, repeat steps 3 through 7.
3.Turn the gas knob		clockwise to off.	9.With the pilot lit, turn the gas knob counter-clock-
4.Wait 5 minutes for any gas in the combustion chamber			wise		to "on" position.
to escape. Continue to the next step if you do NOT smell			10.If your insert is equipped with a flame adjustment valve,
any gas. If you smell gas, STOP! and follow the instruc-			push and turn the knob to "high".
tions in	"What to do if You Smell Gas" listed above.		11.If your insert is equipped with a remote "on-off" switch,
5.If the unit is equipped with a flame adjustment valve,			the main burner may not come on when you turn the gas
turn	clockwise to off.		valve to "on" or "high". The remote switch must be in the
6.Locate the pilot situated in front of the rear log.			"on" position as well to ignite the main burner.
7.Turn the gas knob		counter-clockwise to "pilot"	12.Turn on all electrical power to the insert.
position.
		TO TURN OFF GAS
1.Turn off all electrical power to the unit if service is to be			2.Push in gas control knob slightly and turn			clock-
performed.			wise to off. DO NOT FORCE.

MAINTENANCE

TURN OFF THE GAS AND ELECTRICAL POWER

BEFORE SERVICING THE FIREPLACE.

CAUTION: Label all wires prior to disconnection when ser- vicing controls. Wiring errors can cause improper and dan- gerous operation. Verify proper operation after servicing. This insert and its venting system should be inspected before use and at least annually by a qualified service per- son. The fireplace area must be kept clear and free of com- bustible materials, gasoline or other flammable vapours and liquids. The flow of combustion and ventilation air must not be obstructed.

1.In order to properly clean the burner and pilot assembly, remove the logs to expose both assemblies.

2.Keep the control compartment, logs, burner, air shutter opening and the area surrounding the logs clean by vacu- uming or brushing, at least once a year.

3.Check to see that all burner ports are burning. Clean out any of the ports which may not be burning or are not burn- ing properly.

4.Check to see that the pilot flame is large enough to engulf the thermopile on one leg and reaches toward the burner on the other leg.

5.Replace the cleaned logs.

6.Check to see that the main burner ignites completely on all openings when the gas knob for the burner is turned on. A 5 to 10 second total light-up period is satisfactory. If ignition takes longer, consult your Napoleon dealer / dis- tributor.

7.Check that the door gasketing is not broken or missing. Replace if necessary.

W415-0061 / B / 01.11.05