Document n° | 11 |
MAINTENANCE | D | A |
| ||
| C | |
| B |
Seasonal maintenance
WEEKLY - DESCALE |
|
|
Push and pull the |
|
|
slightly at the same time completely two or three times. Push in for |
|
|
normal burner operations or before relighting. |
|
|
EVERY 3 TO 4 MONTHS - CLEAN BURNER |
|
|
Remove all three catalyser components (C, D, E, figure 13). Remove |
|
|
any carbon residue and remaining oil from the burner using a slightly | F |
|
damp cloth. Buff dry before reinstalling. |
|
|
EVERY 3 TO 4 MONTHS - CHIMNEY INSPECTION |
|
|
The chimney and the chimney connector must be inspected at least |
|
|
once every 3 months during the heating season to ascertain whether |
|
|
there has been a buildup of soot in the system. If a soot buildup has H | E | G |
occurred, it should be removed to reduce the risk of chimney fires. |
| |
|
|
ONCE OR TWICE A YEAR - FLUE BAFFLES INSPECTION | Figure 17 - Float regulator (carburetor) |
| |
- Remove the flue baffles (figure 18 and 19). If a soot buildup has |
|
occurred on the flue baffles and the combustion chamber, it should be removed.
YEARLY - CHIMNEY MAINTENANCE
The chimney is to be swept at least once a year. It is also recommended that prior to every heating season the entire system be professionally inspected, cleaned and repaired where necessary.
YEARLY - CLEAN CARBURETOR FILTER
A : control knob | E : filter |
B : thermostat control | F : main float |
C : oil level regulator | G : safety float |
D : safety lever | H : filter cavity |
1. Set the control knob to “0".
2.Turn off oil supply at the valve or the tank valve.
3.Raise the safety lever (D).
4.Place a container under the carburetor to contain any spillage. Remove the filter plug held on with two screws.
5.Pull out the filter (E) and clean in oil using a soft brush. Never use a wire brush.
6.Replace filter and plug.
Clean all enamelled stove panels and the outside of the glass using a slightly dampened cloth. NEVER CLEAN WHEN
THE STOVE IS HOT.
DOOR GASKET REPLACEMENT
Check the door gasket periodically to ensure the seal is functioning properly and the door fits tight. Replace the gasket if necessary.
Removing the flue baffles
Figure 18 | Figure 19 |
