Napoleon Grills 730 Grill Head Installation, TWO People are Required For this Step

6 x

N570-0073 (1/4-20 x 3/8”)

10Grill Head Installation

PROPANE ONLY - To avoid assembly difficulties, prior to mounting the grill head, remove zip tie holding regulator up under control panel. This was installed at the factory to protect the regulator hose during shipping and is no longer required. (Take care when removing the tie not to damage the hose). Ensure the regulator drops into the small opening, between the tank heat shield and the right side of the cabinet.

Lift grill head and place on assembled cart, lining up holes in top of side cart panels with holes in bottom of base. Fasten from inside using (4)1/4-20 x 3/8”screws, two per side. Install battery pack below vent slots on left hand panel using magnet supplied with battery pack. Plug wire from LED (lights) located underneath control panel into wire from battery pack. Install rotisserie mount bracket to left side of barbecue as shown using (2) 1/4-20 x 3/8” screws.

TWO PEOPLE ARE REQUIRED

FOR THIS STEP

18