WARNING: Do NOT attempt to operate heater until you have read and understand all precaution .
Failure to do so can result in serious personal injury, death, or property damage.
Before Turning Gas Supply ON
Your heater was designed and approved for OUTDOOR USE ONLY. Do NOT use it inside a building ,or any other enclosed area.
Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or liquids.
Ensure that there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are no leaks. Be sure the access panel is clear of debris.
Be sure any component removed during assembly or servicing is replaced and fastened prior to starting.
Before Lighting
Heater should be thoroughly inspected before each use, and by a qualified service person at least annually.
If relighting a hot heater, always wait at least 5 minutes.
Our heater is manufactured under good quality.
There should be at least eight effective times within ten times of ignition.
OPERATION
WARNING
FOR YOUR SAFETY:
If at any time you are unable to light burner and smell gas,wait 5 minutes to allow gas
to dissipate before attempting to light heater. If,after 1 minute, you are unable to light burner, wait 5 minutes and allow flammable vapors to dissipate before attempting to light heater
WARNING
FOR YOUR SAFETY:
Do NOT touch or move heater for at least 45 minutes after use.
Allow emitter and dome to cool before touching.
LIGHTING INSTRUCTIONS
1)Turn the control knob to "OFF" position. 2)Fully open gas valve
3) | Push in control knob and turn counter clockwise to "PILOT" |
| position, push in the ignition button and keep the button depressing untill |
| light the pilot. |
4) | Once the pilot is lit, continue to keep the control knob depressed for at least |
| 30 seconds, After 30 seconds release control knob. |
5) | If pilot does not stay lit, repeat steps 3 and 4. |
6) | If pilot still does not stay lit, then: |
| a) Push in gas control knob and turn counter clockwise to "PILOT" |
L | O | T |
| ||
I |
|
|
P |
|
|
L
O
W
L | O | T |
| ||
I |
|
|
P |
|
|
L
O
OFF
P | |
u | |
| s |
| h |
| t |
| o |
| t |
| u |
| r |
| n |
IG | H |
H |
|
OFF
P |
u |
s |
h |
t |
o |
t |
u |
r |
n |
H |
b) keep depressing the control knob, put long stem lighter into the |
Ignition Hole on the emitter screen to light the pilot. |
c) repeat step 4. |
7) Push in and turn control knob counter clockwise to "HIGH" position, |
If you want a lower temperature, push in the control knob and turn |
clockwise to the "LOW" position. |
If you experience any ignition problem, turn off the heater and gas
supply, and consult "Troubleshooting" on page 14.
W
IG |
H |
Eletronic ignition
Emitter Screen Ignition Hole
10