Menu Commands
The following is a list of menu commands that are shown on the fourth line of the display and selected by using the four function keys
AUTO | Auto – returns the meter to the normal, |
| automatic temperature correction mode. |
ABORT | Abort clearing the memory |
BEGIN | Begin – confirms that the meter is ready to |
| perform time averaging to meet the requirements |
| of a specific standard. |
CABLE | Cable – changes the meter input from fiber optic |
| receiver to the standard cable input. |
CANCEL | Cancel making the selection and return to the |
| previous menu. |
CONT | Continuous – initiate logging for an undefined |
| interval. |
CLEAR | Clear the memory of logged data. |
CLR | Clear the screen and return to making real time |
| measurements. |
DISCARD | Discard this data point without storing it. |
END | End the logging run or averaging interval. |
FO | Fiber Optic – changes the meter input from the |
| standard cable input to the fiber optic receiver. |
FREQ | Frequency – change or enter a frequency. |
GHz | GHz – used to enter a frequency. |
HR | Hours – used to define a logging interval. |
kHz | kHz – used to enter a frequency. |
LEFT | Left – set menus for |
LOG | Log the current measured value. |
32 | Operating the Meter |