MAIN | Main – switch to the Main Measurement Display |
| Screen. |
MAXR | Maximum Reset - reset the maximum value to |
| the instantaneous value. |
MEASURE | Measure – begin the measurement process by |
| selecting and zeroing the probe. |
MEM | Memory – display the available memory. |
MENU | Menu – access the First Menu Screen. |
MIN | Minutes – used to define a logging interval. |
MHz | MHz – used to enter a frequency. |
NO | No – the current probe selection is incorrect. |
| Return to the menu to make another selection. |
OFF | Off – turn special mode off. |
OK | OK – continue with the same setting. |
ON | On – turn special mode on. |
PAUSE | Pause during data logging or time averaging. |
QUIT | Quit special mode and return to the standard |
| measurement screen. |
RESTART | Restart the probe selection and zeroing process. |
RGT | Right – set menus for |
SAVE | Save the data point or the new setting. |
SEC | Seconds – used to define a logging interval. |
SET | Set the time, date, temperature, or display |
| contrast. |
START | Start averaging or data logging. |
STNDS | Standards – access the menu of available |
| exposure standards. |
STOP | Stop the current averaging run. |
YES | Yes – the current probe selection is correct. |
| Proceed with zeroing process. |
Chapter 5 Using the Menu System | 33 |