The Screen should look like this | National LM95235 instruction

6.The Screen should look like this:

Local (on-chip) and remote temperatures should read continuously. The user can experiment with the different settings of Address BF.

7.If the user clicks the 06-FF tab the next screen will look like this:

The user can also select the 3904 diode or the processor thermal diode called “90 nm”.

The user can experiment with the Mask settings. Also the user can change the conversion rate. The next screen shows the possibilities for the Conversion Rate.

www.national.com

Page 6

Image 6

National LM95235 manual The Screen should look like this

Contents

LM95235 Evaluation Board User’s Guide LM95235 Evaluation Board User’s Guide Table of Contents LM95235 Evaluation Board User’s Guide References 1.1Block Diagram 1.0 Introduction 2.0 Quick Start 6. The Screen should look like this Copyright 2006 National Semiconductor Corporation 2.1 Quick Start Diagram Important! NO EXTERNAL POWER SUPPLY OR SIGNAL INPUTS ARE REQUIREDNational Semiconductor Description Connector Label3.0 Functional Description Number 4.0 Software Installation and Operation 4.2 Operation4.1 Installation 5.1 Electrical Specifications Power Requirements 5.2 Electrical Schematic5.0 Electrical and Mechanical Specifications NO EXTERNAL POWER SUPPLY INPUTS ARE REQUIRED 5.3 Evaluation Board Layout Figure 5.3 Layout diagram of the LM95235 Evaluation BoardNote socket and socket area not stuffed Part 5.4 Bill of Materials for LM95235 Evaluation BoardReference PCB Footprint 5.4.2 Evaluation Board Basic Dimensions 5.4 Mechanical Specifications5.4.1 Operating Mechanical and Environmental Specifications 5.4.3 Electrostatic Discharge ESD Precautions LIFE SUPPORT POLICY BANNED SUBSTANCE COMPLIANCE