FP-3000 2 www.natinst.com
Installation
Caution To avoid damaging the FP-3000 and the terminal
bases, make sure that power is not applied to the FP-3000
while you install or remove terminal bases.
Follow these steps to install the FP-3000:
1. Use a flat-bladed screwdriver to open the DIN rail clip to the
unlocked position, as shown in Figure1.
Figure 1. DIN Rail Clip
2. Mount the FP-3000 onto a 35 mm DIN rail or onto a panel
mount accessory.
• Installing onto a DIN rail:
a. Hook the lip on the rear of the FP-3000 onto the top of
a 35 mm DIN rail and press the FP-3000 down onto the
DIN rail, asshown in Figure 2.
Figure 2. Mounting the FP-3000 onto a DIN Rail
Rail Clip LockedRail Clip Unlocked
Cover
Press
35 mm DIN Rail
Lip
Local Bus
Connector