National Instruments cFP-DO-403, FP-DO-403 specifications

FP-DO-403 and cFP-DO-403

These operating instructions describe how to install and use the

National Instruments FP-DO-403 and cFP-DO-403 digital output

modules, referred to inclusively as the [c]FP-DO-403. For

information about configuring and accessing the [c]FP-DO-403

over a network, refer to the user manual for the FieldPoint network

module you are using.

The [c]FP-DO-403 is a FieldPoint digital output module with the

following features:

• 16 sinking digital output channels

• Outputs that sink 2A per channel, 16 A2 per module

• Compatible with voltages from 5 to 30 VDC

• 250 Vrms CATII continuous channel-to-ground isolation,

verified by 2,300 Vrms, 5s dielectric withstand test

• –40 to 70 °C operation

• ON/OFF LED indicators

• Hot swappable

The FP-DO-403 mounts on a FieldPoint terminal base (FP-TB-x),

which provides operating power to the module. Installing the

FP-DO-403 onto a powered terminal base does not disrupt the

operation of the bank.

To install the FP-DO-403, refer to Figure1 and complete the

following steps:

1. Slide the terminal base key to either position X, used for any

module, or position 6, used for the FP-DO-403 module.