© National Instruments Corporation 27 NI RF Signal Generators Getting Started Guide
NI 5442 AWG ModuleThe front panel of the NI 5442 AWG module contains four connectors and
two multicolor LEDs, as shown in Figure 10.
Figure 10. NI 5442 AWG Module Front Panel
Table 7. NI 5442 AWG Module Front Panel Connectors
Connector Purpose
CH 0 Output terminal fo r an IF waveform for upconversion to the desired RF
frequency.
Connect to the IF INPUT connector on the NI 5610 front panel.
CLK IN Output terminal for the AWG module reference clock signal.
Connect to the REF OUT connector on the NI 5610 module front panel.
PFI 0 Bidirectional SMB connectors. As an input, the PFI terminals can accept
a trigger from an external source to start or step through signal generation.
PFI 1