2
The FP-1001 has a simple rail clip for mounting reliably onto a
standard 35 mm DIN rail. To install the FP-1001 to the DIN rail,
follow these steps:
1. With a flat bladed screwdriver, open the DIN rail clip to the
unlocked position as shown in Figure 1.
Figure 1. DIN Rail Clip
2. Hook the lip on the rear of the FP-1001 onto the top of a 35 mm
DIN rail and press the FP-1001 down onto the DIN rail as
shown in Figure2.
Figure 2. Installing the Network Module onto a DIN Rail
3. Slide the FP-1001 to the desired position along the DIN rail.
After the FP-1001 is in position, lock it to the DIN rail by
pushing the rail clip in.
4. Add terminal bases to the DIN rail with their local bus
connectors firmly mated to the FP-1001 local bus connector.
The FP-1001 is shipped with a protective cover over the local
bus connector. Remove this protective cover, and place it over
the local bus connector of the last terminal base in the stack as
shown in Figure3.
Rail Clip LockedRail Clip Unlocked
Press
DIN Rail
C
over
Local Bus
Connector
FP1001.fm Page 2 Thursday, July 31, 1997 8:51 AM