National Instruments 1141, 1142, 1143, SCXI - page 24

Chapter 2 Connecting Signals
SCXI-1141/1142/1143 User Manual 2-10 ni.com
The signals on the rear signal connector are classified as analog output,
digital I/O, or timing I/O signals.
26 SER DAT OUT P0.4 Output Serial data out—this signal taps into
the SCXIbus MISO line to accept
serial output data from a module.
27 DAQ D*/A P0.1 Input Board data/address line—this signal
taps into the SCXIbus D*/A line to
indicate to the module whether the
incoming serial stream is data or
address information.
29 SLOT 0 SEL* P0.2 Input Slot 0 select—this signal taps into
the SCXIbus INTR* line to indicate
whether the information on MOSI is
being sent to a module or Slot 0.
36 SCAN CLK AIH OLD,
AIHO LD COMP
Input Scan clock—a rising edge indicates
to the scanned SCXI module that the
E/M Series DAQ device has taken a
sample and causes the module to
advance channels.
37 SER CLK EXT STROBE* Input Serial clock—this signal taps into
the SCXIbus SPI CLK line to clock
the data on the MOSI and MISO
lines.
43 RSVD RSVD Input Reserved.
Notes: All other pins are not connected.
An * means the signal is asserted low.
Table 2-3. SCXI-1141/1142/1143 Rear Communication Signals (Continued)
Pin
SCXI Signal
Name
NI-DAQmx
Device Signal
Name Direction Description