National Instruments VXI-SC-1102 E, F, G, H, I, L, M, N, P, R

Index
VXI-SC-1102/B/C User Manual I-2
© National Instruments Corporation
E
e-mail support, C-2
EEPROM Register, 4-2
electronic support services, customer
communication
environment specifications, A-4
equipment, optional, 1-6
F
FaxBack support, C-2
filler panel, 1-2
filter specifications, A-3
floating signal connection
referenced to chassis ground (figure), 3-6
front connector pin assignments (figure), 3-2
FTP support, C-1
G
gain and offset calibration, 5-2 to 5-4
Gain Register, 4-2
ground-referencing signals, 3-4
floating signal connection
referenced to chassis ground
(figure), 3-6
ground-referenced signal connection
(figure), 3-5
H
hardware installation. See installation.
I
input damage level, exceeding (warning), 3-4
installation, 2-1 to 2-4
current-loop receivers, 2-3
hardware installation, 2-4
parts locator diagram, 2-2
unpacking the VXI-SC-1102/B/C, 1-7
L
LabVIEW application software, 1-4
LabWindows/CVI application software, 1-4
M
manual. See documentation.
Module ID Register, 4-2
N
NI-DAQ driver software, 1-5
P
parts locator diagram, 2-2
physical specifications, A-3
pinsfront connector pin assignments
(figure), 3-2
front connector signal descriptions
(table), 3-3
power requirements, A-4
R
requirements for getting started, 1-3
resistors
bent and trimmed resistor (figure), 2-3
disconnecting signals before installing
(warning), 2-3
installing current-loop receivers, 2-3