ND-71548 (E) CHAPTER 3
Page 81
Issue 2
INSTALLATION PROCEDURE
4. BRANCHING OF POWER CABLES
NAP-200-008
Sheet 10/13
Connection of Power and Ground
Cables from the Power Equipment
START
Stripping Main and Branch Cable Referring to Figure 008-8, strip insulation coating
with an electrician’s knife. Avoid damage to the
conductor during the stripping process.
Inserting of Cables into Terminal Insert the stripped main wire and branch wire into the
terminal as shown in Figure 008-9.
Clamping for Branch Jointing Place T-Type terminal on the die of the clamping
tool, T-20 - T-44 terminals should be placed on the
center of the die.
T-60 - T-365 terminals should be placed on the die in
such a way that the terminal will be pressed on the
part marked with the roulette.
Proceed with the operation of the clamping tool
referring to Figure 008-10.
Clean the terminal with a dry cloth.
Taping and Covering Referring to Figures 008-11 and 008-12, put an
installation cover over the clamped portion, after
taping with installation tape.
END
3 ROULLETTES
T-154-T-365
NO ROULLETTE
T-20-T-44
2 ROULLETTES
T-60-T-122