10
1.Determine the installation location
* To ensure safe use, see “Before Use” and “Observe
the Following,” then install properly.
2.Connect the equipment
Set the termination switch (75Ω/high impedance).
Set the DIP switches to suit the application and system
structure. (See Page 17.)
(Loop-out connections are for one unit, maximum.)
3.Install the remote control batteries.
* To use the remote control in the wired arrangement,
connect the supplied remote control cable.
4.Connect the supplied power cable
* The maximum current rating 5.6(A) : 42PD1
* The maximum current rating 0.0(A) : 50PD1
5.Switch on the power of each of the
devices
* When connected with a computer, switch on the
power of the computer first.
6.Input an analog RGB signal or a video
signal to this unit
7.Select the input mode
* Select the appropriate RGB input or video input.
8.Adjust the screen
* Make adjustments when adjustment of the screen
display position or distortion is required.
9.Adjust the image
* Make adjustments when adjustment of the tint,
brightness, or contrast is required.
Setup Procedure
Warning
For proper installation and mounting it is strongly recom-
mended to use a trained, authorized NEC dealer.
Failure to follow correct mounting procedures could re-
sult in damage to the unit or injury to the installer.
Product warranty does not cover damage caused by im-
proper installation.
Notice:
This monitor requires the use of a tabletop stand or wall
mount unit for permanent installation and use.
This monitor cannot be used without one of these accesso-
ries.
Note:
RETRACTABLE FEET ARE FOR TEMPORARY USE
ONLY AND ARE NOT INTENDED FOR PERMA-
NENT INSTALLATION.
MODEL # PX-42VPU1-ST STAND IS REQUIRED
FOR PERMANENT TABLETOP INSTALLATION.
REPLACE THE FEET WHEN YOU MOVE THE
MONITOR.