22

Power

The main unit enters the standby mode when the AC cable
is plugged in.
This section describes how to select a computer or video
source and how to adjust the picture.

General Controls

Before you turn on your PlasmaSync 42/50PD1 ensure
that the computer or video source is turned on.
1)To adjust:
1. Turn On The Monitor
The power button is on the front panel of the monitor. By
turning this switch on, the POWER/STANDBY
indicator will turn to green and the monitor will become
ready to use. OSM is also usable from the front panel.
After you press the POWER OFF button on the remote
control, the monitor will go into its standby mode and the
POWER/STANDBY indicator will glow orange.
NOTE:
The set is set to the standby mode when the
power cord is plugged in.
2. Select The Computer Or Video Source
Press the “VIDEO” or “RGB 1” “RGB 2” or “RGB
3”(computer) button on the remote control to display
the image. Or press the button on the front panel to
select your video source: “VIDEO”, “RGB 1”, “RGB
2” or “RGB 3”.

NOTE 1:

In the U.S.A. the standard video signal
format is NTSC, therefore make sure that the AUTO
or NTSC is selected on OSM system control menu.
See page 41.

NOTE 2:

Select the over scan mode for VIDEO
display.
When the RGB input is used, the mode of the power
management function can only be in the off state.
In the absence of TMDS signal input, the unit will be
in the off state.
(The DVI standard DMPM Active-off power state is
equivalent to this.)
The picture will be projected about 4 seconds after
the TMDS signal input returns.
3. Adjust The Raster or The Picture Control.
You can adjust the raster such as the horizontal size,
vertical size and the brightness and contrast of the
image with the remote control.
4. Turning Off The monitor.
Press the POWER OFF button on the remote control or
press the POWER button on the front panel.
Operation

Adjustment of the Display

There are two methods of adjusting the screen/image using
the remote control. One way is direct adjustment by
pressing the various buttons and displaying the desired
adjustment screens. The other way is to select the menu
and display the adjustment screen. This is the menu control
adjustment.
When Using the Power Management Function
This unit is designed for use with power management
function of the VESA DPMS and DVI DMPM system.
When connected with a personal computer or other
equipment incorporating the power management software,
power consumption is reduced while the monitor is not
being used. During power management operation, the
STANDBY/POWER lamp changes color to orange or
yellow.
* The fan may stop during power management operation.
This does not indicate a failure.