NEC 60000531 user manual Quick Start, English-5

Quick Start

To attach the MultiSync V Series monitor to your system, follow these instruction:

1.Turn off the power to your computer and MultiSync monitor.

2.If necessary, install the display card. For more information, refer to the display card manual.

3.For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1) Tighten all screws.

For the Mac: Connect the Macintosh Cable Adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the

15-pin mini D-SUB end of the captive signal cable to the Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

4.Connect one end of the power cord to the MultiSync V Series monitor and the other end to the power outlet (Figure C.1).

5.Turn on the monitor (Figure D.1) and the computer.

6.This completes the installation.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User‘s Manual.

English

Captive Signal Cable

15-pin-mini-D-SUB

Figure A.1

English-5