AppendixEspañolFrançaisDeutsch
English Italiano
Installation

Connection to your Personal Computer

The MultiSync LCD2110 true colour monitor complements PC compatible
computers. Your system has one of two configurations:
– the video controller is built into the computer.
– the video controller is in the form of a display card (sometimes
referred to as graphics card, video adapter or graphics board).
Both configurations have a video connector (or a CRT PORT on laptop
computers). If you are not sure which connector is the video connector,
refer to your computer or display card manual.
E - 8 Installation

To attach the MultiSync LCD2110 monitor to your system,

follow these instructions:

1. Turn off the power to your computer.
2.
Connect the 15-pin mini D-SUB of the appropriate signal
cable to the connector of the display card in your computer
(Figure A.1) (Figure B.1). Tighten all screws.
NOTE: Some Macintosh systems require a Macintosh cable adapter.
3. Remove connector cover on back of monitor. Connect the BNC
cables and AC adapter cable to the appropriate connectors on
the back of the monitor.
If you are using the supplied video signal cable, continue to step 4.
If you are using a 15-pin mini D-SUB cable (not included), please
skip to Step 5.
4. Connect the red BNC cable to the BNC connector on the
monitor labeled R, the green BNC cable to the BNC connector
labeled G/Sync, the blue BNC cable to the BNC connector
labeled B. If you have a fourth BNC connector (Composite
Sync), connect it to the BNC connector on the monitor labeled
HS/CS. If you have a fifth BNC connector (Vertical Sync),
connect it to the BNC connector on the monitor labeled VS
78134811.PM5 99.12.24, 2:19 PM18