NEC HV8600 manual Setting UP the Software, Setting Up Windows NT Enterprise Edition

Setting UP the Software

Software setup for the most part is automatic (approximately 15 minutes) and requires only that you enter name and organization, registration information, internet address, and server parameters. The setup procedures are designed to get your server up and running as quickly as possible. The software is autoloading, requiring minimal intervention on your part. The following sections include the procedures for setting up your server with Windows NT Enterprise Edition.

Setting Up Windows NT Enterprise Edition

The Windows NT software is preloaded on your server and is ready for setup. The Windows NT setup procedures are as follows:

Before beginning these procedures, there is certain requested information that you will need in order to successfully complete setup. This requested information can be recorded in advance on the following "Getting Started Worksheet" for use during setup.

Item	Information Required	Enter Your Information Here
1	Name of NT Server Administrator
2	Organization Name the server will be licensed to
3	OEM License number for MS NT Server Software
	Found on the Certificate of License in the documentation pack
	included with your server
4	Name that you assign to the server
5	IP address assigned to the server’s Ethernet Interface Card
6	Subnet Mask for the server’s Ethernet Interface Card
7	Default Gateway IP address for server’s Ethernet Interface Card
8	IP address of DNS system to be used with the server. (If you
	have a DNS system within your local area or wide area network,
	you may want to use that system.)
9	If you use WINS in your current network, you need the Primary
	and Secondary WINS IP addresses.

Note: If you make a mistake during these setup procedures and you can't return to a previous selection, you must reboot the server immediately.

1.Power up your server (see your Server’s “Getting Started” sheet for procedures).

2.The “Windows NT 4.0 Server” screen with Packard Bell NEC in the upper left-hand side of the screen is displayed. A “Windows NT Setup: setup is initializing.” message momentarily appears on the screen.

4 Server HV8600 System Release Notes