LCD1280 10/29/99 9:25 AM Page 2
Information for LCD1280
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS, UNLESS THE PRONGS CAN BE FULLY INSERTED.
REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION |
RISK OF ELECTRIC SHOCK |
DO NOT OPEN |
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol warns user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact with any part inside this unit.
This symbol alerts the user that important literature concerning the operation and maintenance of this unit has been included. Therefore, it should be read carefully in order to avoid any problems.
FCC Information
The Federal Communications Commission Radio Frequency Interference Statement includes the following warning:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment gener- ates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
DOC Compliance Notice
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
DOC Avis de Conformation
Le presént appareil numérique n’émet pas de bruits radio- électriques dépassant les limites applicables aux appareils numériques de la Class A prescrites dans le Réglement sur le brouillage radioélectrique édicté par le ministére des Communications du Canada.
Contents
Introduction | 1 | Troubleshooting/Support | 9 | |
Contents of Package | 1 | Troubleshooting Chart | 9 | |
Introduction to the NEC LCD1280 |
| Technical Support | 10 | |
True Color Monitor | 1 | BBS | 10 | |
Analog Interface | 1 | FastFacts™ | 10 | |
Reduced Footprint | 1 | Warranty | 10 | |
Low Power Consumption | 2 | Appendix 1 | 13 | |
ErgoDesign™ | 2 | |||
Pin Assignment Table | 13 | |||
Reduced Emissions | 2 | |||
LCD1280 Specifications | 3 | Appendix 2 | 14 | |
Installation | 5 | Signal Timings | 14 | |
Recommended Use | 5 | Appendix 3 | 17 | |
Connection to Graphics Cards |
| |||
| Signal Levels | 17 | ||
using BNC cables | 5 | |||
Controls | 7 | References | 18 | |
Front Controls | 7 | Index | 18 | |
Side Control | 7 |
|
| |
Rear Controls | 7 |
|
|
LCD1280, ErgoDesign, IPM, Reduced Magnetic Field, and FastFacts are trademarks of NEC Technologies, Inc. NEC is a registered trademark of NEC Corporation. Copyright ©1995 by NEC Technologies, Inc. All other brand or product names are trademarks or registered trademarks of their respective holders.
