NEC M700 - page 5

Quick Start

To attach the MultiSync® M700™ monitor to your system, follow

these instructions:

1. Turn off the power to your computer.

2. If necessary, install the display card into your system. For more information,

refer to the display card manual.

3. For the PC: Connect the MultiSync M700 15-pin mini D-SUB of the captive

combined signal cable to the connector of the display card in your system

(Figure A.1). Tighten all screws.

Figure A.1

For the Mac: Connect the Macintosh cable adapter (not included) to the

monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini

D-SUB end of the captive combined signal cable to the Macintosh cable

adapter on the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the MultiSync M700 cable adapter, call

NEC Technologies at (800) 820-1230.

Figure B.1

15-pin mini D-SUB

Captive Combined

Signal Cable

Mac Adapter

(Not included)

15-pin mini D-SUB

Computer

Captive Combined

Signal Cable

15500291.wpc 7/27/99, 3:41 PM5