32
This section describes how to select a computer or video source and how to adjust
the picture and sound.
General Controls Before you turn on your MultiSync MT830+/MT1030+/
MT1035+ LCD Projector, ensure that the computer or video source is turned on
and that your lens cap is removed.
1. Turn On The LCD Projector The main power switch is on the front panel of
the MultiSync MT830+/MT1030+/MT1035+ LCD Projector. By turning this
switch on, the projector will go into its standby mode and the power light will
glow amber. Only after you press the "On" button on the remote control or
projector cabinet will the power light turn to green and the projector become
ready to use.
NOTE: To turn the LCD projector on and off with just the front panel switch,
use the menu and enable the "auto start" feature. (See page 71. )
2. Select The Computer, Video Source Or “Presentation Viewer” Press the
“Video” (VCR, document camera, or laser disc player), “S-video”, “RGB 1” or
“RGB 2” (computer) or PC CARD button on the remote control to display the
image. Or press the “Menu” button on the cabinet and use the icons to select
your video source: “Video”, “S-Video”, “RGB 1”, “RGB 2” or “PC CARD”.
OPERATION3
3. Adjust The Image Size Press the "Zoom" button (+) or (-) on the remote control
or projector cabinet to make the image larger or smaller.
4. Focus Press the "Focus" button (+) or (-) on the remote control or projector
cabinet to focus the image.
5. Turning Off The Projector First press the "off" button on the remote control or
the projector cabinet. The power light will glow amber. Then turn off the main
power switch on the front panel. The power light will go out.

IMPORTANT:

• The LCD projector should be unplugged if it will not to be used for an extended
period.
• To turn off the image briefly (five minutes or less), use the "Picture Mute" button
instead of turning the projector off and on.
• The LCD projector will display a black or blue image if no input signal is present.
• Do not turn the LCD projector off and then immediately back on. The projector
needs to cool for a minute before it can be restarted.
OPERATION
61
62