Remote Control Features
You can use your wireless remote control to operate your MultiSync LT80
Projector. With the remote mouse receiver connected to your computer, you
can also use the projector’s remote control to operate your computer. (See
pages 47 and 48 to connect the remote mouse receiver to your computer.)
NOTE: If you are using a Macintosh computer, you can click either the right or
left button to activate the mouse.
1Left Click Button
Use this button to enter your menu selection. It works the same as the
"Enter" button on the cabinet.
2Laser Pointer
Beams a laser light when “Laser” button is pressed.
3Infrared Transmitter
Direct the remote control toward the remote sensor on the projector cabinet
or the remote mouse receiver.
4LED
Flashes when any button is pressed.
25
POSITION
MAGNIFY
REDUCE
PIC-MUTE FREEZE
VIDEO
RGB
MENU
R-CLICK
LASER
S-VIDEO VOLUME
+
−
+
+
−
−
OFF ONPOWER
4
5
6
8
97
0
1
3
2
5Power On And Off
If your main power switch is turned on, you can use these buttons to turn
your MultiSync LT80 Projector on and off.
6Video Button
Press to select an NTSC, PAL, SECAM or NTSC4.43 compatible video
source from a VCR, DVD player, laser disc player or document camera.
7Volume Buttons
Press (+) to increase the volume and (–) to decrease it.
8S-Video Button
Press to select an S-Video source from a VCR or other S-Video source.
9RGB Button
Press to select a video source from a computer connected to your RGB port.
0Laser Button
Press and hold this button to activate the laser pointer. When lit, you can use
the laser to draw your audience's attention to a red dot that you can place on
any object within 30 feet (10 m).
INTRODUCTION 26