EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an electrical short circuit, earthing reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a earthing wire with a earthing plug. The plug must be plugged into an outlet that is properly installed and earthed.
WARNING : Improper use of the earthing plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the earthing instructions are not completely understood, or if doubt exists as to whether the appliance is properly earthed. If it is necessary to use an extension cord, use only a
INSTALLATION
1.Ventilation
Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause a failure. For proper ventilation, allow 75mm between oven sides and rear. The minimum free space allowed from the top surface of the microwave is 100mm.
2.Steady, flat location
This oven should be set on a steady, flat surface.
This oven is designed for counter top use only.
3.Leave space behind and side
Clearance around all air vents is necessary. If vents are covered during operation, the oven may overheat and could cause permanent damage.
4.Away from radio and TV sets
Poor television reception and radio interference may result if the oven is located close to a TV, radio antenna, feeder and so on. Position the oven as far from them as possible.
5.Position away from heating appliances and water taps
Position your microwave away from hot air, steam or splash as the insulation could be adversely affected and could cause permanent damage.
6.Power supply
•Check your local power source. This oven requires a current of approximately 6 amperes, 240V, 50Hz.
•Power supply cord is about 0.8 meters long.
•The voltage used must be the same as specified on this oven. Using a higher voltage may result in a fire or other accident causing oven damage. Using low voltage will cause slow cooking. No responsibility will be taken for damage resulting from use of this oven with a voltage of ampere fuse other than those specified.
•If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
7.Examine the oven after unpacking for any damage
Examine your oven for damage such as: misaligned door, broken door, a dent in the cavity. If any of these are visible, DO NOT INSTALL your microwave and notify your dealer immediately.
8.Do not operate the oven if it is colder than room temperature
This can occur if delivery occurs in very cold weather. Allow the oven to return to room temperature before operation.
3
