NEC NHD-3000PVR HDMI Video

󳀝

Control HDMI video output.

1. Press MENUbutton.

2. Use ,button to highlight icon, then press OK.

3. Use ,button to highlight HDMI Video, then press OK.

4. Press , button to make a choice, then press OK.

HDMI means the value of video timing is setup for HDMI

󳀭It will take a few seconds to set HDMI video mode, if mode selection is changed from HDMI to YPbPr/RGB

or vice versa.

󳀭HDMImode supports HDMI1080i, HDMI720p, HDMI576p, 1080i, 720p, 576p, and 576i . One of the

above seven output video formats can be selected by V.FORMATbutton. In HDMI mode, HDMI1080i,

HDMI720p, and HDMI576p are shown in Status (by pressing the MARKbutton) as H1080i, H720p,

and H576p, respectively.

YPbPr/RGB means the value of video timing is setup for YPbPr/RGB

󳀭YPbPr/RGB mode supports 1080i, 720p, 576p, and 576i. One of the above four output video formats

can be selected by V.FORMATbutton.

󳀭If display device works well by receiving HDMI siginal from NHD-3000PVR in YPbPr, RGB video mode,

you may use the HDMI video output without changing to HDMI mode.

HDMI Video

09

42

Audio / Video

Press MENU button to exit the menu screen.

Press EXITbutton to switch to previous step on the menu screen.

Contents

Main Page Important Safeguard CAUTION : Page About the internal hard disk drive Page Table of Contents Supplied Accessories Buttons Front Display Controls Front Side Front Panel Controls and LEDs LED Indicators Rear Panel Connectors Rear Panel Connectors (Cont.) Battery Installation for Remote Control Antenna Input Connection to Digital TV (YPbPr) Connection to Digital TV (RGB/HV) Connection to RGB PC Monitor Connect the HDMI Cable Connection to Digital TV (HDMI/DVI) < Digital TV > Installation Connection to HDMI/DVI PC Monitor Connection to Analog TV (Composite/S-Video) Connect the Digital Audio Output Installation Connection to Digital Audio Amplifier < Audio Amplifier > Remote Control Button Description Remote Control (Cont.) Button Description Channel Information Press the INFO button to display the following screen. Page Channel Status Channel List Press LIST button to select channel on Channel List menu. Timeshift Control Press T.SHIFTbutton to start timeshift. Press REC/EDIT button to select recording time. Record Control (Dual Recording) Timer Record List Show the Timer Record List. Show the Program List. Program List Program List (Rename) Control Playback. Playback Control EDIT Control (Repeat, Cut, Split) Control Repeat, Cut & Split. Page Teletext PIP Control Control PIP channel. Memorize your choice of channels. Channel Edit Channel Scant Manual Scan Channel Sorting Channel Duplication Select Channel Duplication Option. Parental Rating Set Parental Guidance Rating. Control HDMI video output. HDMI Video HDMI Audio Control HDMI audio output. Monitor Setup Digital Audio Out PIP Size Vol. Control Turn on and off the remote controller volume control functionality. PVR Manager Program List The Program List shows the recorded programs. (You can also bring up the Program List by pressing the P.LISTbutton on the remote control.) Skip Time HDD Sleep Time PVR Manager HDD Format Formats the HDD. All the recorded programs will be deleted. Opacity Control opacity (transparent) of menu screen. Time Zone Select time zone. Daylight Saving Select daylight saving. Sleep Timer New Password Change the 4-digit password. Factory Default Set Factory Default. About Specifications Specifications SPECIFICATIONSITEM NEC Service Centres NEC Australia Pty. Ltd. ABN 86 001 217 527 DISPLAY AND HOME GROUP