3. Projecting an Image (Basic Operation)
Selecting a Source
Selecting the computer or video source
NOTE: Turn on the computer or video source equipment connected to the projector.
Selecting from Source List
Press and quickly release the SOURCE button on the projector cabinet to display the Source list. Each time the SOURCE button is pressed, the input source will change as follows: “COMPUTER”, ”VIDEO”,
Detecting the Signal Automatically
Press and hold the SOURCE button for a minimum of 2 seconds, the projector will search for the next available input source. Each time you press and hold the SOURCE button for a minimum of 2 seconds, the input source will change as follows:
V230X/V260/V230:
COMPUTER → VIDEO →
V300X/V260X:
COMPUTER 1 → COMPUTER 2 → VIDEO →
TIP: If no input signal is present, the input will be skipped.
Using the Remote Control
V230X/V260/V230: Press any one of the COMPUTER 1, VIDEO, and
V300X/V260X: Press any one of the COMPUTER 1, COMPUTER 2, VIDEO, and
Selecting Default Source
You can set a source as the default source so that it will be displayed each time the projector is turned on.
1.Press the MENU button. The menu will be displayed.
2.Press the button twice to select [SETUP] and press the button or the ENTER button to select [GENERAL].
3.Press the button four times to select [OPTIONS(2)].
4.Press the button six times to select [DEFAULT SOURCE SELECT] and press the ENTER button.
The [DEFAULT SOURCE SELECT] screen will be displayed. (→ page 64)
5.Select a source as the default source, and press the ENTER button.
6.Press the EXIT button a few times to close the menu.
7.Restart the projector.
The source you selected in step 5 will be projected.
TIP: When the projector is in Standby mode, applying a computer signal from a computer connected to the COMPUTER IN input will power on the projector and simultaneously project the computer’s image.
([AUTO POWER ON(COMP.)] for V230X/V260/V230/[AUTO POWER ON(COMP1)] for V300X/V260X → page 64)
V230X/V260/V230
V300X/V260X
V230X/V260/V230
V300X/V260X
20