3. Projecting an Image (Basic Operation)

Correcting Keystone Distortion

Correcting Keystone Distortion

If the screen is tilted vertically, keystone distortion becomes large. Proceed with the following steps to correct keystone distortion

NOTE:

•The Keystone correction can cause an image to be slightly blurred because the correction is made electronically.

•The Keystone correction range can be made narrower, depending on a signal or its aspect ratio selection.

Adjusting with buttons on the cabinet

1.Press the () or () button with no menus displayed. The keystone bar will be displayed.

   

2.Use the or to correct the keystone distortion. Adjust so that the right and left sides are parallel.

3.Press the ENTER button.

The keystone bar will be closed.

NOTE: When the menu is displayed, the above operation is not available. When the menu is displayed, press the MENU button to close the menu and start the Keystone correction.

From the menu, select [SETUP] → [GENERAL] → [KEYSTONE]. The changes can be saved with [KEYSTONE SAVE]. (→ page 55)

24