NEC VT37 Connecting Your DVD Player with Component Output, Installation and Connections, Audio In

2. Installation and Connections

Connecting Your DVD Player with Component Output

AUDIO COMPUTER IN

VIDEO IN L/MONO AUDIO R

COMPUTER IN

S-VIDEO IN	PC CONTROL
	AC IN

Optional 15-pin - to - RCA (female)

×3 cable (ADP-CV1)

Audio Equipment

AUDIO IN

L R

DVD player

L R

AUDIO OUT

Audio cable (not supplied)

Component video RCA×3 cable (not supplied)

Y Cb Cr

Component

You can connect your projector to a DVD player with component output or Video output. To do so, simply:

1.Turn off the power to your projector and DVD player.

2.If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component video cable (RCA×3) and the optional 15-pin-to-RCA (female)×3 cable to connect your DVD player to the COMPUTER IN connector on the projector.

For a DVD player without component video (Y,Cb,Cr) output, use common RCA cables (not provided) to connect a composite VIDEO output of the DVD player to the Video Input of the projector.

3.Connect the supplied power cable. See page 18.

4.Turn on the projector and DVD player.

A component signal will be automatically displayed. If not, from the menu, select [Advanced] → [Signal Select] → [Computer], and then place a check mark in the Component radio button.

NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.

16