1. Introduction

Battery Installation

1 Press firmly and slide the battery cover off.

2 Install new batteries (AAA). Ensure that you have the batteries' polarity (+/–) aligned correctly.

3 Slip the cover back over the batteries until it snaps into place. Do not mix different types of batteries or new and old batteries.

Remote Control Precautions

•Handle the remote control carefully.

•If the remote control gets wet, wipe it dry immediately.

•Avoid excessive heat and humidity.

•Do not heat, take apart, or throw batteries into fire.

•If you will not be using the remote control for a long time, remove the batteries.

•Ensure that you have the batteries’ polarity (+/-) aligned correctly.

•Do not use new and old batteries together, or use different types of batteries together.

•Dispose of used batteries according to your local regulations.

Operating Range for Wireless Remote Control

Remote sensor on projector cabinet

7m/22feet

30°

30°

(*)

30°

30°

7m/22feet

Remote control

*NOTE: The VT590, VT490, VT59 and VT49 do not have the remote sensor on the rear panel.

•The infrared signal operates by line-of-sight up to a distance of about 22 feet/7 m and within a 60-degree angle of the remote sensor on the projector cabinet.

•The projector will not respond if there are objects between the remote control and the sensor, or if strong light falls on the sensor. Weak batteries will also prevent the remote control from properly operating the projector.

8