2. Installation and Connections

￿Making Connections

NOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby mode and before turning on the power to the notebook PC.

In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered up.

*If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power management software.

Enabling the computer’s external display

Displaying an image on the notebook PC’s screen does not necessarily mean it outputs a signal to the projector. When using a PC compatible laptop, a combination of function keys will enable/disable the external display. Usually, the combination of the ‘Fn” key along with one of the 12 function keys gets the external display to come on or off. For example, NEC laptops use Fn + F3, while Dell laptops use Fn + F8 key combinations to toggle through external display selections.

Connecting Your PC or Macintosh Computer

NOTE: • VT695/VT595: The COMPUTER 1 connector supports Plug & Play (DDC2).

•VT590/VT490/VT59/VT49: The COMPUTER connector supports Plug & Play (DDC2).

VT695/VT595

VT590/VT490/VT59/VT49

 

COMPUTER 1 IN

 

S-VIDEO

LPC CTRL COMPUTER 2 (DVI-I) IN AUDIO IN

1 IN

IN

 

COMPUTER IN

 

MONITOR

1)

 

 

S-VIDEOLPC CONTROL MONITOR OUTCOMPUTER IN

VIDEO

AUDIO IN

IN

 

R

VIDEO IN AUDIO IN

Audio cable (not supplied)

PHONE

VGA signal cable (supplied)

To mini D-Sub 15-pin connector on the projector. It is recommended that you use a commercially available distribution amplifier if connecting a signal cable longer than the cable supplied.

NOTE: For older Macintosh, use a commercially available pin adapter (not supplied) to connect to your Mac's video port.

IBM VGA or Compatibles (Notebook type) or Macintosh (Notebook type)

NOTE: The projector is not compatible with video decoded outputs of either the NEC ISS-6020 and ISS-6010 switchers.

NOTE: An image may not be displayed correctly when a Video or S-Video source is played back via a commercially available scan converter.

This is because the projector will process a video signal as a computer signal at the default setting. In that case, do the following.

*When an image is displayed with the lower and upper black portion of the screen or a dark image is not displayed correctly: Project an image to fill the screen and then press the AUTO ADJ. button on the remote control or the projector cabinet.

13