ADSL Modem Router Setup Manual
b.The LAN port LEDs are lit for any local ports that are connected.
c.The ADSL Internet port LED is lit.
If a port’s LED is lit, a link has been established to the connected device. If a LAN port is connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10 Mbps, the LED will be amber.
If any of these conditions does not occur, refer to the appropriate following section.
Power LED Not On
If the Power and other LEDs are off when your router is turned on:
•Make sure that the power cord is properly connected to your router and that the power supply adapter is properly connected to a functioning power outlet.
•Check that you are using the power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact technical support.
Test LED Never Turns On or Test LED Stays On
When the router is turned on, the Test LED turns on for about 10 seconds and then turns off. If the Test LED does not turn on, or if it stays on, there is a fault within the router.
If you experience problems with the Test LED:
•Cycle the power to see if the router recovers and the LED blinks for the correct amount of time.
If all LEDs including the Test LED are still on one minute after power up:
•Cycle the power to see if the router recovers.
•Clear the router’s configuration to factory defaults. This will set the router’s IP address to 192.168.0.1. This procedure is explained in “Using the Reset Button” on page
If the error persists, you might have a hardware problem and should contact technical support.
Troubleshooting |
v1.1,
