NETGEAR GS524T manual Installation, Preparing the Site, Checking Package Contents

CHAPTER 4: INSTALLATION

This chapter describes the installation procedures for the NETGEAR Model GS524T Copper Gigabit Switch.

Preparing the Site

Before you begin installing your switch, prepare the installation site. Make sure your operating environment meets the operating environment requirements of the equip- ment listed in Table 4-1.

Table 4-1. Operating Environment Requirements

Characteristic	Requirements
Temperature	Ambient temperature between 0 and 40ºC (32 and 104ºF).
	No nearby heat sources such as direct sunlight, warm air exhausts, or heaters.
Operating humidity	Maximum relative humidity of 90%, noncondensing.
Ventilation	Minimum 2 inches (5.08 cm) on all sides for cooling.
	Adequate airflow in room or wiring closet.
Operating conditions	At least 6 ft (1.83 m) to nearest source of electromagnetic noise
	(such as photocopy machine or arc welder).

Power

Adequate power source within 6 ft (1.83 m).

Checking Package Contents

Unpack the contents of the package and verify them against the following list:

•NETGEAR Model GS524T Gigabit Ethernet Switch

•Self-adhesive rubber footpads for desktop installation

•Rack Mount Kit for rack installation

•AC power cord

•Warranty & Owner Registration Card

installation 4-1