Installation Guide
Start Here
Follow these instructions to set up your router.
Verify That Basic Requirements Are Met
Assure that the following requirements are met:
•You have your broadband Internet service settings handy.
•The computer is configured to obtain an IP address automatically via DHCP. For instructions on how to do this, please see the animated tutorials on the 54 Mbps Wireless Router Resource CD or Appendix C in the Reference Manual on the CD.
First, Connect the Router to the Internet
1Connect the Router Between Your PC & Modem
a.Turn off your computer and cable or DSL modem.
b.Disconnect the Ethernet cable (A) which connects from your computer to the cable or DSL modem.
A
Cable or DSL modem
c.Securely insert the Ethernet cable from your cable or DSL modem into the Internet port (B) on the WGR614.
Internet Port
B |
54 Mbps Wireless | Cable or DSL modem |
Router WGR614 |
|
d.Securely insert one end of the Ethernet cable that came with your router into a LAN port on the router such as LAN port 4 (C), and the other end into the Ethernet port of your computer (D).
D | LAN Port 4 |
|
C |
| |
|
| |
| 54 Mbps Wireless | Cable or DSL modem |
| Router WGR614 |
|
2Restart Your Network in the Correct Sequence
Warning: Failure to restart your network in the correct sequence could prevent you from connecting to the Internet.
a.First, turn on the cable or DSL modem and wait 2 minutes.
b.Now, turn on your router.
c.Last, turn on your computer.
Note: If software usually logs you in to the Internet, do not run that software or cancel it if it starts automatically.
Power | Test | Internet Port | LAN Port 4 |
d.Check the status lights and verify the following:
•Power: The power light is on. It goes on when your turn the router on.
•Test: The test light is off. After turning on the router, the test light should go off in less than a minute.
•Internet: The Internet light on the router is lit. If the Internet light is not lit, check that the Ethernet cable is securely attached to the router Internet port and the powered on modem.
•LAN: A LAN light is lit. If none are lit, check that the Ethernet cable to the router from the powered on computer is securely attached at both.
3Log in to the Router
a.From your PC, launch your Internet browser.
b.Connect to the router by typing http://192.168.0.1 in the address field of Internet Explorer or Netscape® Navigator.
c.Enter admin for the router user name and password for the router password, both in lower case letters.
d.After logging in to the router, you will see the Internet Connection Setup Wizard on the settings main page.
