RangeMax NEXT Wireless Access Point WN802T Reference Manual
2-10 Installation and Configuration
v1.0, June 2006
–DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless
access point will get its IP address, subnet mask and default gateway settings
automatically from the DHCP server on your network when you connect the WN802T to
your LAN.
–IP Address. Enter the IP Address of your wireless access point.The default IP address is
192.168.0.233. To change it, enter an unused IP address from the address range used on
your LAN; or enable DHCP.
–IP Subnet Mask. The Access Point will automatically calculate the subnet mask based on
the IP address that you assign. Otherwise, you can use 255.255.255.0 (the default) as the
subnet mask.
–Default Gateway. Enter the IP address of the gateway for your LAN. For more complex
networks, enter the address of the router for the network segment to which the wireless
access point is connected. The default is 0.0.0.0.
–Primary DNS Servers. The WN802T will use this IP address as the primary Domain
Name Server used by stations on your LAN. The default is 0.0.0.0.
–Secondary DNS Servers. The WN802T will use this IP address as the secondary Domain
Name Server used by stations on your LAN. The default is 0.0.0.0.
4. From the pull-down menu, select the local Time Zone for your wireless access point from a
list of all available time zones. The default is GMT.-08:00
5. Check the Adjust for Daylight Saving Time if your location uses daylight savings. The
default is no adjustment.
6. Click Apply to save your Basic IP settings.
Configuring Wireless Settings
The following sections describe how to configure the wireless settings for both the 802.11b/g/Next
and 802.11b/g modes.
To configure the RangeMax NEXT wireless settings of your wireless access point:
1. From the main menu under Setup, select Wireless Settings.The Wireless Settings screen will
display as shown in Figure 2-8 below
Note: If you do not have an Internet connection to get the current time, the wireless
access point will get the current time from the connecting PC.